WANTED, E46 325 EXHAUST AND MANIFOLD?
As above gents, I have most of the parts sourced for a conversion, engine, box loom ecu key, and am on the lookout for an exhaust and manifold, could be separate or both,
Any leads or phone numbers to one too would be greatly appreciated, thanks to page for donating a lot of bits too, I'm getting the engine from dane on drivers,
Thanks, mick.:smiling:
RE: WANTED, E46 325 EXHAUST AND MANIFOLD?
might have one or both exhaust manifolds ,but will know on Friday only probably .
RE: WANTED, E46 325 EXHAUST AND MANIFOLD?
I was told m52 manifolds onto a twin pipe e46 set up would be great to do??? Any thoughts?
RE: WANTED, E46 325 EXHAUST AND MANIFOLD?
Quote:
Originally Posted by MICK FORAN
I was told m52 manifolds onto a twin pipe e46 set up would be great to do??? Any thoughts?
depends what engine u fitting and what ECU it will have
RE: WANTED, E46 325 EXHAUST AND MANIFOLD?
Had a set there for the longest time! Swapped them recently for a set of screwdrivers off a tinker... Typical!
RE: WANTED, E46 325 EXHAUST AND MANIFOLD?
http://cars.donedeal.ie/view/7940194
This engine with matching loom,
E46 exhausts seem to be hard to get compared to the amount of body parts out there???
Have a tight budget on this one, and have to get Christmas over with first too!
I appreciate all the information and advice,:smiling:
RE: WANTED, E46 325 EXHAUST AND MANIFOLD?
Have a set of lambda's there if you like..
RE: WANTED, E46 325 EXHAUST AND MANIFOLD?
Quote:
Originally Posted by michael320
Have a set of lambda's there if you like..
I will take you up on that mike, how much are you looking for them?
RE: WANTED, E46 325 EXHAUST AND MANIFOLD?
Have both manifolds with cats and full exhaust from E46 6 cylinder, 150€ all in for lot
RE: WANTED, E46 325 EXHAUST AND MANIFOLD?
they are yours if you want them, send me your number and il meet you next week
RE: WANTED, E46 325 EXHAUST AND MANIFOLD?
Quote:
Originally Posted by michael320
they are yours if you want them, send me your number and il meet you next week
Cheers mick, are ye still up in the same place working?
Thanks a mill mate!
0861938880 :wink: