INPA & DIS issues

Long story short, the hard disk on my diagnostic laptop crashed - I was able to retrieve the BMTechnic software but alas, with the new hard disk in place, the software now requires an activation code and with BMTechnic gone under, I wont be able to get a new code.

I was so disappointed as it was a great piece of kit and never ran into any issues with it.
So, here lies my issue - I bought new software and cable from http://bcables.com/ .
Installed the software etc and then tried to connect to the car. Strange thing is that I can read the DME module, clear errors etc but it won't read any of the other modules. I just get an error 'NO RESPONSE FROM CONTROL UNIT'. This is the same for both INPA & DIS. I thought it might have been my car, but it's exactly the same with my dad's E46 318Ci.

Now, last weekend, I connected my brothers E87 116i and low and behold, everything works on that! I can read all the modules via INPA and DIS with no errors..

Can anyone shed some light to this please. wIll get the versions later but I think INPA is v57.

Did you check the port settings associated with your Com port? The latency should be set to 1, it defaults to 16.

Yep Mark, it's set to COM1. Strange that it works on the E87 and not our E46s. It's configured correctly to K Can too.

I had the exact same issue. The E46 requires two K-lines, you will have to bridge two pins on your cable or buy an adapter which does this for you.
I'll try dig up a link

Man that's annoying...I still have the BM Technics cable...would this work with the bcables software i wonder?

http://www.bmwhaus.ie/forum/showthread.php?tid=3056

Thanks for that John. Did your interface have a switch at the back to switch between K & D Can? Mine does

No I just hard wired it but I may install a switch in the future. At the moment I only use it on the E46 so that was the quickest solution.

Surely if you have the switch that should do the trick..? Confusing.

Quote:

---

Originally Posted by John_D

No I just hard wired it but I may install a switch in the future. At the moment I only use it on the E46 so that was the quickest solution.

Surely if you have the switch that should do the trick..? Confusing.

---

Yeah if it has the switch the bridging is already done so.... the plot thickens:happy:

Quote:

---

Originally Posted by 318 iS Cosmos

Man that's annoying...I still have the BM Technics cable...would this work with the bcables software i wonder?

---

I would think it should work, give it a go.

Update on this - checked the com port settings and latency and all was fine. I flicked the switch over to D CAN and didn't change anything else and hey presto everything works now on both INPA & DIS


Sent from my iPhone using Tapatalk

Quote:

---

Originally Posted by 318 iS Cosmos

Man that's annoying...I still have the BM Technics cable...would this work with the bcables software i wonder?

---

I think the bcables software requires a bcables cable to work. However you BMTechnics cable will work fine with any INPA DIS set up that is not bcables.