Printable View
Bought this on eBay after giving the touring a full service, all fluids changed including gearbox oil, diff oil etc I wanted to reset the oil service I know you can jump with pins 7 and 19 but don't fancy doing that.. Anyway plugged in the reset tool followed instructions and not a peep! It's now on the amber light! Any suggestions
http://tapatalk.imageshack.com/v2/14...96ba4cf935.jpg
Why are you afraid to jump the pins? It's tried and tested and is what this tool does anyway just grounds the pin. Certain e36s my own included need to be reset put diagnostics cover back on then turn off car. Try that.
I used a resistor to short mine, I was worried about blowing something the same as you are, about 250 ohms was the value I used. Just take your time to make sure you have the right pins. Hope this helps
I used the paperclip on both of my e36 but it would sometimes take several attempts, just make sure your at the correct pins
I've been using a paperclip on mine for as long as I have the car and it's never failed me
If you're anywhere near Tipperary or Kilkenny I can meet you and reset it for you with the Draper reset tool that I have.
Forgot to say.
Make sure you have the ignition on ( key turned to acc ) but car not started. The reset tool takes its power from the car.
You probably did this anyway but just in case.
This is what I use available from HALFRAUDS limerick and most motorfactors.
http://tapatalk.imageshack.com/v2/14...4ab005ce5d.jpg
Sent from my GT-I9300 using Tapatalk
I've used the Draper tool for years. Well worth the €12 I paid for it, works every time.
Got back at it this evening used the paper clip method and it reset fine.