Printable View
I'm skimming the discs on the M5, just because I can tbh. And to be sure there's no imbalance anywhere.
The rear handbrake shoes are "ridged" enough, surprisingly, seeing as the matching face of the handbrake friction area is quite smooth.
Would ye bother replacing the shoes lads? The handbrake is... adequate, at best.
Sent from my D5803 using Tapatalk
I'd adjust it up if they look ok..
Sent from my SM-G920F using Tapatalk
Seems to be the general consensus!
Sent from my D5803 using Tapatalk
I don't think I've ever had a BMW with a handbrake like a Japanese appliance. I think it would probably be a waste. I always leave the car in gear on a hill and turn the wheel against the kerb. Save the penny's for petrol I'd say!
Yea it's disappointing really. Skimmed the discs last night, fronts were fine, rears were not.
A good clean up of all the handbrake gubbins and fingers crossed.
Sent from my D5803 using Tapatalk
I have a very good handbrake in the e36 and same when i had the e39. The 630i is pain useless, no matter what I do.Quote:
Originally Posted by Smokey Bear
For both the e36 and e39 I did change the handbrake shoes with the discs (& pads), the shoes are pricey for what they are!! (I got OEM ones at the time).
On close inspection, the top spring is missing on one side, and unhooked on the other! Like, wtf?
Sent from my D5803 using Tapatalk
The springs definitely lose their springiness over time, I also replaced the springs and locking pins on the e36, there was a bit of a rattle every now and again from the shoes and it cured that. I could see how the springs might fail. I bought a second spring/lock pin set for the e36 by mistake too, so if you're ordering note you only need one set.Quote:
Originally Posted by Tristan
So. Got a full fitting kit, same day, from RAE Autofactors in Roscrea. Only 10 euro, so couldn't be bothered rooting around the breakers.
Turned out it was actually one of the BOTTOM springs, the one that pulls the shoes against the threaded adjusters. Wtf!!???
I could have refitted the one that had somehow ended up caught at the top, but fired in a new one anyway.
Loose spring
https://uploads.tapatalk-cdn.com/201...673817f77a.jpg
Now, if any of you folk are stuck for any of the mounting bits for your BMW, you're welcome to what's in the picture.
All new apart from the dirty one. Which is fine tbh.
Mintex, not oem.
https://uploads.tapatalk-cdn.com/201...c5f9a43bcf.jpg
Sent from my D5803 using Tapatalk