ok so i fitted the AC schnitzer ssk to the e36 and there is a slight knocking in 2nd and fourth gear as itf its hitting the prop, why is this happening? shifts feel so precise and short and this crap happens :mad:
Printable View
ok so i fitted the AC schnitzer ssk to the e36 and there is a slight knocking in 2nd and fourth gear as itf its hitting the prop, why is this happening? shifts feel so precise and short and this crap happens :mad:
is the prop with the big balancer drum on it? if so, knock it off, its not needed.Quote:
Originally Posted by claudio
if the prop is without balancer drum you need to bend a bit the actual shifter rod, or make a new one thats 2mm shorter, it means gearstick will slightly (not noticable) be towards rear of the car
I'm not sure which prop is on it
I think it's one with the drum
I wasn't actually fitting it
if its with the drum, you can beat the drum off just with hammer.Quote:
Originally Posted by claudio
Ok that doesn't sound good
Is there any negative effect from taking it off ???
not really. as newer props comes without those drums, guibo and prop bearing does the job anyway.Quote:
Originally Posted by claudio
Bb1981 had the same issue with his short shifter.
i had it tough. 2 was not going in and 4th with a touch. simple fixQuote:
Originally Posted by Moses
HAMMERTIME....
So I'm confused
Should I remove it and take 2 mm of the end or remove the weigh off the prop as Armando said
Is thee any damage being done at the moment
Thanks