E36 airbag light issue

[ChrisJ]

I recently replaced the seats in My 318is and in a rush to get the job done, I snipped the 2 wires running up into the seats from underneath. The new seats are Vaders and don't have anything to connect these to.
What way can I get rid of the airbag light that's now on the dash?Ni heard someone say to use resistors but what value? Also do I need it coded or whatever to get rod of the light after that?
Thanks in advance,

Chris

[ChrisJ]

Cool, thanks. What type of resistors? Like what value or ohms or whatever they're measured in?

[ChrisJ]

Anyone??????

[Gar]

Might be of use http://www.adverts.ie/5359591

[KevinF]

Measure the resistance of the original seats if you still have them and post it up here, I've a selection of resistors here I'll post you one of the correct value if you measure it.

[ChrisJ]

Thanks Lads. I dont have the seats still sadly but thanks anyway. If I fond out the correct value I might give you a PM though
Gar, that night just be the job. Not a clue how to wore it up and dunno if I should be letting this guy wore it as he has offered???

[ChrisJ]

So these are the 2 wires in question.
Is the emulator Gar posted a simple, hook it up and the light goes off or what's involved? Will it work?
Thanks again,

Chrisimage.jpg

[nigzcurran]

On my e46 the airbag bypass was a plug and play jobby, you should have a connecter originally on those wires before ye cut them?

Sent from my C2105 using Tapatalk

[ChrisJ]

Shit...Woops.

[ChrisJ]

So where do I go from here anyone?