Here it is in a nut shell over the past 2 years I have a constant fault 18 inpa or 0369 obd reader, exhaust cam sensor, work so far done with fault still showing no change no matter what I have done. Passed 2 nct's with very low emissions. Car is 01 520 with m54 engine
Replaced vanos seals
Replaced exhaust cam sensor twice febi and oem (2nd hand confirmed operational on donor car)
Replaced intake sensor
Switched solenoids
Cleaned pistons
Numerous oil changes 6k interval
Rebuilt vanos again (car ran fantastic for 2 weeks loads power ect then back to normal)
I know sensor is working as when I turn.the car over by hand voltage on sensor stitches 0 to 5 volts
My question is where to from here
(1)is it cam timing
(2)vanos unit (when rebuilt only thing was bearings on.piston.were a bit grumbly)
(3)dme, I have read that there was an update to take into account "noise " or interference that may effect cam signal is this to do with m52 engine only.
Is the dme fcuked?
(4)should I get a brand new oem sensor
(5)vanos oil supply line replace?
(6)Anything else I should be looking at
If it were your car where would go next all suggestions bar burning it welcome :wink:
Cheers