The easiest route to go is to code out the sensor.

NOTE, if you do go that route you need to code out the driver and passenger settings in the module, even though there is no driver's side occupancy sensor. If you only change one line then you will brick the airbag control module. The control modules are relatively cheap second hand (€20-40, plus coding) but why go down that route.



ERKENNUNG_SITZBELEGUNG_1
aktiv -> nicht aktiv
ERKENNUNG_SITZBELEGUNG_2 aktiv -> nicht aktiv

Plus you need to disconnect the black box with blue writing under the seat, before you code out the mat. i.e. The box should not be connected back in to the car. It is connected to the sensor may one one side and the yellow block connector on the other side, it's the yellow block connector side of that needs to be disconnected. Note only disconnect the connector for the sensor may inside this yellow connector, you still need the seat belt tensioner. Better still, remove the box from the car.