Nilfisk

[nigzcurran]

Lads my connection is leaking water everywhere! Am I missing a part?


Sent from my iPhone using shitetalk

[hamish262001]

O ring?

Sent from my XT1068 using Tapatalk

[nigzcurran]

I thought that but it's not even connecting to the washer, I tried a few different o rings but no improvement
Edit seems your right, it's missing a small o ring from the tip. Probably better replacing the hose as its ancient anyhow, I reckon the old o ring is stuck in the gun connection and is preventing the hose from connecting properly

Sent from my iPhone using shitetalk

[schoonerm3]

Yea missing a small o ring unfortunately. You might pick one up on eBay if you measure the diameter

[JohnC]

Measure the diameter

I have a few small o rings left over from an engine build kit that I wont be using

[nigzcurran]

I only have a big builders measuring tape, would that be precise enough?


Sent from my iPhone using shitetalk

[Gar]

Iv an o ring pick and a digital calipers if you wana drop down tomorrow

Sent from my SM-T230 using Tapatalk

[nigzcurran]

Cheers man see ye then


Sent from my iPhone using shitetalk

[hamish262001]

If you are still stuck I have a complete box of assorted o rings to pick from

Sent from my XT1068 using Tapatalk

[nigzcurran]

If you are still stuck I have a complete box of assorted o rings to pick from

Sent from my XT1068 using Tapatalk

Cheers only seeing this now, was in mcquillans earlier and picked a set up, should get one out of this hopefully IMG_3205.JPG


Sent from my iPhone using shitetalk