BST fault reset

[rebel.ranter]

Didn’t, no. Am I too late for that though? If not, any step-by-step how-to guide available?


Sent from my iPhone using Tapatalk

It's not too late at all. It may not yield anything but no harm to try:

http://blog.obdii365.com/2015/05/18/...pert-software/

[Colm_D]

So, just this afternoon discovered something new I can do with INPA; although I’m getting 2ohms resistance locally at the battery terminal itself, when I open the ignition circuits page on the airbag module on INPA, circuit 10, battery clamp is showing zero ohms apart from a little sporadic flicker of 1.005 ohms. Connection issue possibly. Might temporarily solder in a 2 ohm resister and see how I get on.


Sent from my iPhone using Tapatalk