Results 1 to 4 of 4

Thread: BMW N62 Valve Stem Seal replacement

  1. #1
    BMWHaus Site Sponsor
    Join Date
    Jul 2013
    Posts
    2,360

    BMW N62 Valve Stem Seal replacement

    Another problem and its solving ,if You have a smoking BMW with N62 engine,mostly its due to bad valve stem seals. The valve stem seal problem is that the old valve stem seal becomes hard over time and doesn’t provide the proper seal between the seal and stem. This allows oil to pass through and enter the combustion chamber and exhaust. In addition, the old style seal does not seal on the inside to the guide, like the newer updated style seal. This creates an oil pocket underneath the seal that oil can accumulate in and make the problem worse. The oil consumption here is bad for a lot of different reasons. Obviously smoking, but also decreased cat life and blockage of secondary air ports. So we got this BMW with exactly same problem . New valve stem seals fitted ,new rocker cover gasket sets , VVTI motor gaskets and spark plug new tubes ,these common to oil leak on to spark plugs and causing engine misfiring ,so heres some pictures of this job .
    By the way, some garages do offer head remove for this job or half head strip ,as camshaft and VVTI system removal is needed to get this job done ,but thanks to special tools we do offer this service without remove of any of these parts .
    Thanks for reading and enjoy the pictures !

    rocker covers removed ,all removed parts and bolts stored for operation
    IMG_1082.JPGIMG_1083.JPGIMG_1084.JPGIMG_1085.JPGIMG_1086.JPG

    seal replacement tools ,cylinder leakage test tool to hold the pressure in cylinders to keep valves in their place when spring is removed ,and new stem seals
    IMG_1087.JPGIMG_1089.JPGIMG_1090.JPG

    First fitted in , and heres the difference between new and old seal ,the center hole is stretched and rubber of its time and heat is hard and not flexible anymore
    IMG_1091.JPGIMG_1093.JPG

  2. #2
    BMWHaus Site Sponsor
    Join Date
    Jul 2013
    Posts
    2,360

    RE: BMW N62 Valve Stem Seal replacement

    half of work - one head is done ,still 16 left :hehe!:
    IMG_1092.JPG IMG_1096.JPG

    new parts ready to do the job
    IMG_1095.JPG

    rocker covers cleaned in and out and with new gasket fitted on
    IMG_1097.JPGIMG_1098.JPGIMG_1099.JPGIMG_1100.JPG

    rocker covers fitted back,VVTI motor gaskets on and engine back in one peace
    IMG_1102.JPGIMG_1104.JPGIMG_1106.JPG

    Thanks for Your attention :wink:

  3. #3
    BMWHaus Guru
    Join Date
    Jul 2013
    Posts
    1,784

    BMW N62 Valve Stem Seal replacement

    Nice work Valdas. Great to be able to do it without removing heads.

  4. #4
    Moderator
    Join Date
    Jul 2013
    Posts
    8,000

    Re: BMW N62 Valve Stem Seal replacement

    V8 e60 not many of them knocking about

    Engines very clean too good work as always thanks for sharing nice to get a peek inside the newer stuff

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •