Okay lads I'm after getting hold of a new set of bride bucket seats (reps) and a set of sparco seat bases specific for e36/46.. Just only question is when I'm swapping out the seats will the seat belt receiver be able to transfer over to the new seats.? Haven't got the car at the moment so can't really have a look to line things up (99 e36 coupe).. And will I need anything else for the install?
pictures of the seats you intend to put in? As a facelift car you have the pre tensioner with the explosive charge so airbag lights may become an issue. I'd pm super4 as he has had and is putting in similarOriginally Posted by murphykidd
I used e30 receivers. No pre tensioner no messing about just bolt on
Forgot to reply my bad.. Got the job done anyways was abit of work but happy with the way it turned outgoing for a drift spec kind of look for the summer with the brides and harnesses,, don't no what to make of the harasses but the missus said to keep them so I suppose itl keep her happy somebit haha..
any pics of how you fit them?
It's hard to tell from the picture, but it looks like the harnesses might be mounted too low at the rear. They need to be as close to 90 degrees as possible, so you might need a proper harness bar. The results of having a tip with incorrectly mounted harnesses can be extremely dangerous, you're much better off using the standard three point belts.
Oh I don't use them man there just mounted to the rear buckle points like And then onto the floor pan bolts on the seat, just there for the look really, I just still use the original belt like..
Posting Permissions
Reply With Quote