Hey guys!
Got my hands on a HK amp a while ago .... Unfortunately I can't find an amp wiring diagram anywhere to retrofit it to my 325ci.
Has anyone by any chance done this before or have a diagram?
Jimmy
Sent from my iPad using Tapatalk
Hey guys!
Got my hands on a HK amp a while ago .... Unfortunately I can't find an amp wiring diagram anywhere to retrofit it to my 325ci.
Has anyone by any chance done this before or have a diagram?
Jimmy
Sent from my iPad using Tapatalk
What did u get? The entire system is different, speakers are different aswell, youd need the monitor loom hk amp bm54 amp and all speakersOriginally Posted by Jimmy325ci
There's an awful lot more to fitting the amp than just the amp itself. There's the switch pack under the climate controls, lower impedance speakers, more speakers, the sub tray under the parcel shelf, canbus connections, the new loom. Honestly, if you have just the amp, you're better off selling it, and then putting in brand name high end speakers to where you're stock speakers are.
Thanks for the advice guys. Was kinda hoping that I would connect it up in some way ... Anyway! Any one interested in a HK Amp
what are the specs of it jimmy? looking for a amp to power my speakers. presume this works same as a normal 4 way amp?Originally Posted by Jimmy325ci
Haven't a clue ... It needs a multi plug. I'll bring it on Thursday to show u.
Sent from my iPhone using Tapatalk
you dont happen to have that multi plug do you? not sure if ill make it thursday hopefully doing the bushings and clutch so see what time we get doneOriginally Posted by Jimmy325ci
You need the complete HK wiring harness. Trying to make it out yourself is a waste of time and will most likely be wrong.Originally Posted by Jimmy325ci
The harness is different if your car is a coupe or saloon
It is also different depending on the build date of the car as the amp went through a few hardware revisions too. So you may buy one that is not going to fully fit your amp.
A complete plug and play already made wiring harness from the dealer from example, with part number 61116918151 costs around 600 euros.
Now you may be spending that amount of money, install everything and end up with no sound as your amp may be faulty. A lot of those amps become faulty after a while.
You can buy 6 channels amps brand new amp for less money that loom costs and you will have more power per channel.
You can get the harness used as well, but usually breakers don't bother removing the carpet to take all the wires in one piece, they cut it in half with one end only available to you. Try to figure out how to wire the other end.
If you are lucky enough to find a used in one piece, then you still run the risk of ending up with the wrong harness for your car and a faulty amp too.
My 2 cents