Results 1 to 6 of 6

Thread: Icv + throttle body clean M54

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #4
    Moderator
    Join Date
    Jul 2013
    Posts
    8,000

    Re: Icv + throttle body clean

    Again q tips are you friend here there was a nice build up on the icv the piece inside moved freely but moved a lot better once cleaned try clean the moving piece in the middle as much as you can I then flushed it out with boiling water

    If no afters of this I forgot ,it came up spotless though
    uploadfromtaptalk1375652938506.jpg

    And lastly clean the disa

    Then to put it all back start with the icv first make sure it sits snug into its rubber grommet place two torx screws back

    Next throttle body 4 10mm bolts and done reconnect connector blocks to icv and throttle body

    Now place the vacuum hose back one bolt holding it and place back the black connector box lastly place the disa back with the 2 torx bolts

    Then replace both rubber boots and finally the airbox itself

    uploadfromtaptalk1375653323494.jpg

    Conclusin took it for a short drive on the dunboyne/lucan backroads spent 45 minutes out there throttle response is excellent(some placebo possibly) pulling like a train right from take off and no more odd idle with revs moving up and down sits rock solid at 700rpm

    Total cost 0 euro unless you find any problems

    Rubber boot 30e
    Flexi hose - free
    Seal (which I should have bought) about 3 euro
    Attached Images Attached Images

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •